Battery input & protection
Quote the input interface and requested protection components. Battery packs, BMS and chargers are outside the quoted line.
POWER
Power components and interfaces.
5 blocks. Review operating duty, receiving interface and supplier documentation before selection.
Battery input & protection
Loaded and charged pack range; continuous and peak current; inrush/reverse protection requirements; disconnect and live-mating conditions.
Requirements & interfaces ↗
DC-DC conversion
Full input range; required output rails; continuous/peak current; isolation requirement.
Requirements & interfaces ↗
Current measurement
Pack, branch or phase location; current range; bandwidth and accuracy; analog or supported digital output.
Requirements & interfaces ↗
AC-DC — plugged-in single axis
Mains input range; output voltage/current; continuous power; installation and thermal conditions.
Requirements & interfaces ↗
Brake & logic auxiliary rail
Loads requiring a separate rail; voltage/current and startup; shutdown sequence; isolation and retention requirements.
Requirements & interfaces ↗Selection boundaries
DC-DC conversion
Examples include a nominal 48 V system supplying 24 V, 12 V or 5 V rails. Actual input limits must include charge voltage, sag and applicable transients.
Current measurement
Match isolation, common-mode range and receiver requirements. A measurement component alone is not a certified protective function.
AC-DC — plugged-in single axis
This block applies to plugged-in axes and fixed equipment. It is not a supply block for battery mobile platforms.
Brake & logic auxiliary rail
A separate rail does not imply stored energy or ride-through. For a spring-applied brake, removing coil power engages the brake; any retained supply must follow the validated stop sequence.
SUPPLY SCOPE
System context outside the quoted line.
Battery packs · BMS · chargers · LiDAR · safety scanners · cameras · navigation computers · fleet software.
Battery packs, BMS, chargers, navigation computers, LiDAR, safety scanners, cameras and fleet software are outside our quoted component line. We consider only the specified power and connector interfaces to those devices.
PROJECT / MODULE / COMPONENT
Equipment projects and integration modules
Outdoor automation
Commercial tracked mowing, sweeping and grounds maintenance.
Explore requirements & interfaces ↗Agriculture & field equipment
Farm/ranch UTV transport and field work.
Explore requirements & interfaces ↗Commercial vehicle electrical interfaces
Controller power, auxiliary rails, vehicle network and service connectors. Software, OTA and fleet services are outside the quoted line.
Explore requirements & interfaces ↗Vehicle control & by-wire
Driver intent, torque requests, energy coordination and defined actuator interfaces.
Explore requirements & interfaces ↗Battery, BMS & charging
Pack energy, protection, state estimation and a charger matched to the site.
Explore requirements & interfaces ↗Telematics & vehicle networks
CAN acquisition, gateway routing, location and cellular data transport.
Explore requirements & interfaces ↗